CIE A Level Physics复习笔记20.1.9 Velocity Selection

• A velocity selector is defined as:

A device consisting of perpendicular electric and magnetic fields where charged particles with a specific velocity can be filtered

• Velocity selectors are used in devices, such as mass spectrometers, in order to produce a beam of charged particles all travelling at the same velocity
• The construction of a velocity selector consists of two horizontal oppositely charged plates situated in a vacuum chamber
  • The plates provide a uniform electric field with strength E between them
• There is also a uniform magnetic field with flux density B applied perpendicular to the electric field
  • If a beam of charged particles enter between the plates, they may all have the same charge but travel at different speeds v
• The electric force does not depend on the velocity: F_E = EQ
• However, the magnetic force does depend on the velocity: F_B = BQv
  • The magnetic force will be greater for particles which are travelling faster
• To select particles travelling at exactly the desired the speed v, the electric and magnetic force must therefore be equal, but in opposite directions

F_E = F_B

The particles travelling at the desired speed v will travel through undeflected due to the equal and opposite electric and magnetic forces on them

• The resultant force on the particles at speed v will be zero, so they will remain undeflected and pass straight through between the plates
• By equating the electric and magnetic force equations:

EQ = BQv

• The charge Q will cancel out on both sides to give the selected velocity v equation:

• Therefore, the speed v in which a particle will remain undeflected is found by the ratio of the electric and magnetic field strength
  • If a particle has a speed greater or less than v, the magnetic force will deflect it and collide with one of the charged plates
  • This would remove the particles in the beam that are not exactly at speed v
• Note: the gravitational force on the charged particles will be negligible compared to the electric and magnetic forces and therefore can be ignored in these calculations

Part (a)

Step 1:            Direction of E field

• • • • • Electric field lines point from the positive to negative to charge
        • Therefore, it must be directed vertically upwards

Step 2:            Direction of B field

• • • • • Using Fleming’s left-hand rule:
          • The charge or current I is to the right
          • B is out of the page
          • Therefore, the force F is vertically downwards

Part (b)

Velocity selector equation

Electric field strength, E = 2.8 kV m^-1 = 2.8 × 10³ V m^-1

Magnetic flux density, B = 0.50 T

Part (c)

If the speed increases, the magnetic force must be greater because F_B ∝ v

Since the magnetic force would direct the ion downwards in the direction of the field, the ion will be deflected towards the positive plate