AQA A Level Biology复习笔记1.1.11 Finding the Concentration of Glucose

• Benedict’s solution can be used to carry out a semi-quantitative test on a reducing sugar solution to determine the concentration of reducing sugar present in the sample
  • It is important that an excess of Benedict’s solution is used so that there is more than enough copper (II) sulfate present to react with any sugar present

   

• The intensity of any colour change seen relates to the concentration of reducing sugar present in the sample
  • A positive test is indicated along a spectrum of colour from green (low concentration) to brick-red (high concentration of reducing sugar present)

   

• A semi-quantitative test can be carried out by setting up standard solutions with known concentrations of a reducing sugar (such as glucose)
• These solutions should be set up using a serial dilution of an existing stock solution
• Each solution is then treated in the same way: add the same volume of Benedict’s solution to each sample and heat in a water bath that has been boiled (ideally at the same temperature each time) for a set time (5 minutes or so) to allow colour changes to occur
  • It is important to ensure that an excess of Benedict’s solution is used

   

• Any colour change observed for each solution of a known concentration in that time can be attributed to the concentration of reducing sugar present in that solution
• The same procedure is carried out on a sample with an unknown concentration of reducing sugar which is then compared to the stock solution colours to estimate the concentration of reducing sugar present

Alterations

• It is also possible to standardise this test but instead of waiting a fixed amount of time for a range of colours to be observed, time how long it takes for the first colour change to occur (blue to green)
  • The higher the concentration of reducing sugar in a sample, the less time it would take for a colour change to be observed

   

• To avoid issues with human interpretation of colour, a colourimeter could be used to measure the absorbance or transmission of light through the sugar solutions of known concentration to establish a range of values that an unknown sample can be compared against a calibration curve

Serial dilutions

• Serial dilutions are created by taking a series of dilutions of a stock solution. The concentration decreases by the same quantity between each test tube
  • They can either be ‘doubling dilutions’ (where the concentration is halved between each test tube) or a desired range (e.g. 0, 2, 4, 6, 8, 10 mmol dm-3)

   

• Serial dilutions are completed to create a standard to compare unknown concentrations against
  • The comparison can be:
    • Visual
    • Measured through a calibration/standard curve
    • Measured using a colourimeter

     

  • They can be used when:
    • Counting bacteria or yeast populations
    • Determining unknown glucose, starch, protein concentrations

     

   

Making serial dilutions

Colourimeter

• A colourimeter is an instrument that beams a specific wavelength (colour) of light through a sample and measures how much of this light is absorbed (arbitrary units)
• They provide a quantitative measurement
• They contain different wavelengths or colour filters (depends on the model of colourimeter), so that a suitable colour can be shone through the sample and will not get absorbed. This colour will be the contrasting colour (eg. a red sample should have green light shone through)
  • Remember that a sample will look red as that wavelength of light is being reflected but the other wavelengths will be absorbed

   

• Colourimeters must be calibrated before taking measurements
  • This is completed by placing a blank into the colourimeter and taking a reference, it should read 0 (that is, no light is being absorbed)
  • This step should be repeated periodically whilst taking measurements to ensure that the absorbance is still 0

   

• The results can then be used to plot a calibration or standard curve
  • Absorbance against the known concentrations can be used
  • Unknown concentrations can then be determined from this graph

   

A colourimeter is used to obtain quantitative data that can be plotted to create a calibration curve to be used to find unknown concentrations